Trimming and Linearization

Topics

Simulink Control Design

• Compute Steady-State Operating Points (Simulink Control Design)
  To obtain a steady-state operating point, you can trim your model using numerical optimization techniques or simulate your model until it reaches a steady-state condition.
• Linearize Nonlinear Models (Simulink Control Design)
  Obtain a linear approximation of a nonlinear system that is valid in a small region around an operating point.
• Choose Linearization Tools (Simulink Control Design)
  Simulink Control Design software lets you perform linear analysis of nonlinear models using a user interface, functions, or blocks.
• Linearize Simulink Model at Model Operating Point (Simulink Control Design)
  Linearize a model at its operating point consisting of initial state values and input signals.
• Linearize at Trimmed Operating Point (Simulink Control Design)
  You can linearize a Simulink model at an operating point that meets specified input, output, or state constraints.

  Simulink

  • Linearizing Models
    Describes functions that extract a linear state-space model from a Simulink model.
  • Use Model Name as Programmatic Interface
    Use the name of a model as a programmatic interface to execute a specified simulation phase and compute results for specified states and time.

    Related Information

    • Simulink Control Design
      

    You clicked a link that corresponds to this MATLAB command:

    Run the command by entering it in the MATLAB Command Window. Web browsers do not support MATLAB commands.

    Close